5 accepted papers
In tendon-driven robotic hands, tendons are usually routed along several pulleys. The resulting friction is often substantial, and must therefore be modelled and estimated, for instance for accurate control and contact detection. Common approaches for friction estimation consider special dedicated s…
In contrast to underactuated robotic hands the DLR AWIWI II hand of the David robot is fully controllable because each finger with 4 joints is actuated by 6 or 8 tendons respectively. For such fingers all joint angles (generalized positions) or joint torques (generalized forces) can be controlled in…
Standard industrial controllers of robot arms define constraints on the velocity, the acceleration, and the jerk and abort execution in case any of them is violated. In addition to satisfying these constraints, the presented method tries to generate a trajectory that is path-accurate, i.e., that exa
Industrial robots are often used for the simulation of satellites during on orbit servicing. In order to cover also the docking phase, both robots are equipped with force-torque sensors, and the measured forces and torques are taken to compute the desired motion of the position controlled robots. Si…
Stopping the motion of industrial robots in response to warnings or unexpected sensor data is a special case of trajectory generation. In contrast to emergency stops, here the robot has to satisfy the limits of the acceleration and the jerk. In addition, during the deceleration the robot must follow…